Funkwerk Bintec WI-Client Especificaciones

bintec WI-ClientWLAN Ethernet Client Adapter WLAN Serial Client Adapter ManualWI-Client Manual Version 2.16 V3 1

Wireless pageConfiguring the WLAN interfaceThe WLAN radio can be switch off or here. Wireless modeInfrastructure = Connect to APAd hoc = peer to peer

Security page Setting up the security optionsIf the user selects the 802.1x authentication the PSK or the WEP-Keys don’t have to be defined because th

Admin pageSetting up administration rights and configure basic features, update firmwareWi-ClientOption to block the bridging funktion of the Wi-Clien

Advanced pageThe advanced page offers more detailed options to define the behavior of the WI-Client in the WLANenvironment.CloningThe cloning paramete

RoamingRoaming is the term for automatically changing to another access point when the WI-Client recognizes adecreasing RF signal level when leaving t

Illustration 11: Advanced pageWI-Client Manual Version 2.16 V3 15

Serial interface setupThe WI-Client can have one or two serial interfaces, depending on the options. Each interface is configuredon its own WEB page.N

Umlenkung. This tool enables the WI-Client to connect to serial devices over LAN/WLAN. Afterinstallation of the software enter the WI-Client IP addre

“Keep alive“ settingsA TCP/IP connection remains open after being established until one of the communicating devices closesthe connection. If the phys

6) 3964R: This is a special protocol which is commonly used for communication with SPS(programmable control systems). This protocol uses special chara

Content:Overview

Power supply connectorThe WI-Client is equipped with a circular M8- 3pin connector. The connection is as follows:Illustration 15: Power supply connec

Legal NoticeAim and purposeThis document is part of the user manual for the installation and configuration of funkwerk devices. Forthe latest informat

OverviewThe WI-Client is intended to connect devices with ethernet or serial interfaces to a Wireless Local AreaNetwork (WLAN) corresponding to the 80

The ethernet port has a RJ45 plug. Because of the auto MDI functionality the WI-Client can be attached to aHUB or the LAN port of a computer with stan

Technical features:Processor Type 32bit network processor 250MHz clockMemory 256KByte program (internal)64KByte data (internal)4MByte flash (external)

First Time Setup To set up the WI-Client it has to be connected with a patch cable to the ethernet interface of a computer.Because of the auto MDI/MDI

Illustration 4 screenshot of the ComPoint ManagerAll located WI-Client-Devices are shown in list. A click to a device opens a sub window to change the

Parameter setting via WEB interfaceInformation pageGeneral information regarding firmware versions and status reportsIllustration 5: Information pageO

Access Point page Information on all access points currently available to the WI-Client. Illustration 6: Access Point pageWI-Client Manual Version 2.1