Funkwerk Bintec WI-Client Especificaciones descargar pdf (Pagina 10)

Wireless page

Configuring the WLAN interface

The WLAN radio can be switch off or

here.

Wireless mode

Infrastructure = Connect to AP

Ad hoc = peer to peer connection

SSID, Service Set Identifier.

Name of the WLAN network.

This name must be the same as the

access points SSID

Transmission rate.

Best = automatic depending on signal

strength.

If useful, you can select a fixed

bitrate.

802.11 mode.

802.11b = 2.4GHz 11MBit

802.11g = 2.4GHz 54MBit

802.11b/g = 2.4GHz 11 + 54MBit

802.11a = 5GHz 54MBit

AP Density:

influences the roaming behaviour

Super mode: is not supported

Country

Select the country in which the

ESCG is used. This determines the

number of available channels.

802.11a Frequency Bands:

possible channel restriction for the 5GHz

(802.11a) operation.

Channel

This channel has to be selected

in ad hoc mode only

Antenna mode

single = when one antenna is used

diversity = when two antennas are

used. With two antennas the radio

can select the antenna that delivers

the best signal.

The Transmit Power can be adjusted

here.

Illustration 7: Wireless page

By clicking the “Save“ button all changes on this page are stored. Use “Cancel” to undo any changes. After

clicking “Save” the program prompts the user to make a reboot. This should be done after all necessary

changes on all pages have been made.

WI-Client Manual Version 2.16 V3 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comentarios a estos manuales

Sin comentarios

Funkwerk Bintec WI-Client Especificaciones Pagina 10

Comentarios a estos manuales