Funkwerk Bintec WI-Client Especificaciones descargar pdf (Pagina 4)

The ethernet port has a RJ45 plug. Because of the auto MDI functionality the WI-Client can be attached to a

HUB or the LAN port of a computer with standard patch cables. The WI-Client recognizes the cable polarity

and automatically connects the right signal lines.

The serial port is a 9 pin female D-SUB connector. The pinout makes it possible to connect to a computer

COM port with a 1 to 1 serial cable, the exact pinout is shown in Illustration above.

The power supply should be 9 – 35VDC / 3W. At 12VDC the input current is typical 250mA.

Back and front view:

LINK

100MBit

54321

9876

+ VB

RP-SMA antenna connector

Option for a 2. antenna connector

PIN Function Dir.

1 DCD IN

2TxDOUT

3RxDIN

4DSRIN

5GND

6DTROUT

7CTSIN

8RTSOUT

9RIIN

Illustration 2 Connections and LEDs

LED Function

On Green always on when power is on

WLAN Red blinking searching for RF-connection (scanning)

Steady green found a suitable Access-Point and established

a connection

Green blinking 802.1x Authentification is in process

Green + red blinking

RF activity (receive or transmit)

LAN Off no link is recognized

Green link is established with another LAN device.

Green + red blinking

activity on the LAN interface

Ser1 (2) Off interface is inactive or not connected to the

other (W)LAN-.communication side

Green connected to other serial device.

Green + red blinking

activity on the serial interface (receive or

transmit)

WI-Client Manual Version 2.16 V3 4

1 2 3 4 5 6 7 8 9 ... 20 21

Comentarios a estos manuales

Sin comentarios

Funkwerk Bintec WI-Client Especificaciones Pagina 4

Comentarios a estos manuales