Funkwerk WI2040n Manual de usuario descargar pdf (Pagina 237)

Field Description

• 67 3 ?2" ": For sending RIP V2 messages over

the multicast address 224.0.0.9.

• 67 3 4$$: RIP V1 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

• 67 3 4$$: RIP V2 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

Receive Version Decide whether routes are to be imported via RIP and if so, se-

lect the RIP version for receiving RIP packets over the interface

in receive direction.

Possible values:

• 8 (default value): RIP is not enabled.

• 67 3: Enables sending and receiving of version 1 RIP

packets.

• 67 3: Enables sending and receiving of version 2 RIP

packets.

• 67 353: Enables sending and receiving of both version 1

and version 2 RIP packets.

• 67 3 4$$: RIP V1 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

• 67 3 4$$: RIP V2 messages are sent, received

and processed as per RFC 2091 (triggered RIP).

Route Announce Select this option if you want to set the time at which any activ-

ated routing protocols (e.g. RIP) are to propagate the IP routes

defined for this interface.

Note: This setting does not affect the interface-specific RIP con-

figuration mentioned above.

Possible values:

• ,!  9" (not for LAN interfaces, interfaces in Bridge

mode and interfaces for leased lines): Routes are propagated

if the interface status is up or ready.

• ,! <2-: Routes are only propagated if the interface status

is up.

• 2- : Routes are always propagated independent of oper-

ational status.

Funkwerk Enterprise Communications GmbH

14 Routing

bintec WLAN and Industrial WLAN 225

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 431 432

Sin comentarios

Funkwerk WI2040n Manual de usuario Pagina 237