Funkwerk WI2040n Manual de usuario descargar pdf (Pagina 30)

Access data Example value Your values

Preshared Key #$ "

MAC address of remote bridge %%%%&%'

To use the bridge link autoconfiguration function, proceed as described in the Automatic

Configuration of a Bridge Link workshop and read the Wireless LAN chapter of the

user's guide under WLAN -> Bridge Links -> Add.

4.3.2 Configuring a PC

In order to reach your device via the network and to be able to carry out configuration, the

PC used for the configuration has to satisfy some prerequisites.

• Make sure that the TCP/IP protocol is installed on the PC.

• Select the suitable IP configuration for your configuration PC.

The PC via which you want to configure the IP address for your device must be in the

same network as your device.

Checking the Windows TCP/IP protocol

Proceed as follows to check whether you have installed the protocol:

(1) Click the Windows Start button and then Settings -> Control Panel -> Network Con-

nections (Windows XP) or Control Panel -> Network and Sharing Center->

Change Adapter Settings (Windows 7).

(2) Click on LAN Connection.

(3) Click on Properties in the status window.

(4) Look for the Internet Protocol (TCP/IP) entry in the list of network components.

Installing the Windows TCP/IP protocol

If you cannot find the Internet Protocol (TCP/IP) entry, install the TCP/IP protocol as fol-

lows:

(1) First click Properties, then Install in the status window of the LAN Connection.

(2) Select the Protocol entry.

(3) Click Add.

(4) Select Internet Protocol (TCP/IP) and click on OK.

(5) Follow the on-screen instructions and restart your PC when you have finished.

Allocating PC IP address

4 Basic configuration Funkwerk Enterprise Communications GmbH

18 bintec WLAN and Industrial WLAN

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 431 432

Sin comentarios

Funkwerk WI2040n Manual de usuario Pagina 30